Additional information
| Size | 8' x 100', 9' x 100', 10' x 100', 10'4" x 100', 12'4" x 100', 14' x 300', 8'4" x 100', 9'4" x 100' |
|---|
4 mil Clear Fire Retardant Film 12′ x 100′
$48.95
This clear polyethylene sheeting is a vapor barrier for walls and floors. Prevents condensation and energy loss. Size 12′ x 100′.
J&R Products offers FREE SHIPPING for all domestic orders that total over $50 and are shipping to the lower 48 states. If you are needing items shipped outside of this area, please give us a call at 1-800-343-4446 to complete your order.
Additional information
Related products
Milspec Pro Power SJTW Extension Cord 12 AWG (100′, Black)
The 100', black Milspec Pro Power SJTW Extension Cord 12 AWG is made of soft-drawn, bunch-stranded copper conductors with large strain reliefs at both ends for enhanced durability. This 100' 3-pin male to female extension cord is manufactured with cold-weather insulating and jacketing compounds.
- 100% copper conductors
- Cold-weather insulating and jacketing compounds
- Supports up to 300 VAC
- Up to 15A current draw
- Suitable for use indoors and outdoors
- Water-resistant thermoplastic jacket
Energy Guardian Pull Down Cover-Standard
The Energy Guardian Kits for Pull Down Ladders R-38
This is the UPS Friendly Version of EG-113 and comes in two boxes. The lid is in two pieces and the frame is in six pieces. The outside dimensions are 61 x 33 x 17.75 and the inside dimensions are 55 x 27 x 10. The Energy Guardian Kits- Named BEST AVAILABLE PRODUCT by Fine Homebuilding Magazine and A Green Product that You Should Know About in This Old House.com! It's the choice of the most respected home performance experts and the fastest growing solution for homeowners across the country. They are made in the USA by a Veteran Owned Company. Pull down ladders and push up hatches cost money and create uncomfortable areas in any home in both hot and cold weather. The patented design of The Energy Guardian Kits meets all Code and Department of Energy minimum requirements* for your pull down ladder or push up hatch. Important The U.S. Department of Energy published minimum requirements for all pull down ladder covers and push up hatches. *See: http //sws.nrel.gov/sites/default/files/sws_singlefamily_0.pdf, page 74. Use this checklist to compare any alternative:| Essential Features | The Energy Guardian |
| Made of non-compressible, rigid insulation* (no batt insulation) | YES |
| Durable Protective barrier around the attic entrance* | YES |
| A 20-year service life for the product* | YES |
| Insulating value equal to the rest of the attic* | YES |
| Provide a Durable air seal* | YES |
| Can install with uneven or no decking | YES |
DO IT ONCE, DO IT RIGHT with THE ENERGY GUARDIAN KITS
R-6 Water Heater Jacket
Vinyl-faced fiberglass blanket for gas, oil, or electric water heaters up to 60 gallon capacity. Each jacket is individually bagged and vacuum packed for efficient storage. SDS
Tenmat FF109-300 2-hour Fire Rated Light Cover
The FF109X is the only two hour UL tested and approved fire barrier that can be used with a wide range of recessed lights to effectively prevent the spread of flames through a ceiling opening. Once a hole is made in the drywall to install recessed lights or speakers, the integrity of the construction and its ability to perform in a fire is reduced significantly, creating a potential fire hazard. This is the reason why the International Building Code states: “Where floor/ceiling assemblies are required to have a 1 or 2-hour fire resistance rating, recessed fixtures shall be installed such that the required fire resistance of the ceiling will not be reduced” The FF109X is two hour approved for every major ceiling assembly including gypsum, sheetrock, drywall, acoustical tiles and suspended ceilings with any joist spacing up to 24 inch on center. The enclosure is made out of an intumescent material which will be activated in case of a fire, stopping both, flame spread and heat transmission for two hours. Tenmat 2 Hour Fire Rated Light Covers are UL tested and approved for use with IC-rated recessed incandescent, fluorescent, LED light fixtures. TENMAT Fire Rated Light Covers can be used with most light manufacturer’s models and are suitable for new construction as well as remodel projects. In addition to its fire protection capabilities, the FF109X also exhibits excellent thermal and acoustical insulating properties to save energy and reduce noise. The flexible and lightweight nature of the covers makes installation quick and easy, reduces the stress put on the ceiling and significantly reduces labor costs compared to standard dry-walled box constructions. Data Sheet (PDF)